Comments on: Zero Clearance Plate for Table Saw https://www.woodlogger.com/zero-clearance-plate-for-tablesaw/ Adventures of an American Woodworker Sat, 22 Apr 2023 20:09:04 +0000 hourly 1 By: Spruce Wayne https://www.woodlogger.com/zero-clearance-plate-for-tablesaw/comment-page-1/#comment-4305 Wed, 03 Feb 2016 23:34:15 +0000 http://blog.woodlogger.com/?p=119#comment-4305 Does this plate have any flex? Seems very thin without any support glued as a second layer?

]]> By: Vincent Morelli https://www.woodlogger.com/zero-clearance-plate-for-tablesaw/comment-page-1/#comment-2686 Mon, 02 Feb 2015 06:05:07 +0000 http://blog.woodlogger.com/?p=119#comment-2686 I tried to make one,out of hardwood, it turned out quiet well I just did not feel safe with it. I have a Craftsman table saw and the original was piece of crap. I got a new one from Amazon Leecraft it fit right in and it is strong as can be, it has a strong clip as well as a screw to make it fit tight. I had a few close encounters with things falling into the machine with the original plate. I think that plate from Sears was a terrible safety hazard. Everyone is so concerned about kick back the forget the other dangers. A zero clearance plate is a must.

]]> By: WoodLogger https://www.woodlogger.com/zero-clearance-plate-for-tablesaw/comment-page-1/#comment-2619 Tue, 06 Jan 2015 02:58:02 +0000 http://blog.woodlogger.com/?p=119#comment-2619 In reply to Larry Leasure.

Mine just snaps into place. It’s sized just right. Magnet is a great idea though.

]]> By: Larry Leasure https://www.woodlogger.com/zero-clearance-plate-for-tablesaw/comment-page-1/#comment-2609 Tue, 30 Dec 2014 23:21:16 +0000 http://blog.woodlogger.com/?p=119#comment-2609 How did you hold your home made insert in saw? The front of mine is held with mag.

]]>